![]() Adjustments for leap years and Daylight Savings Time are automatically set. If displaying the date, it can show the month, day, and year. The 12 hour format has the option to show AM or PM. Either format can indicate hours and minutes, or hours, minutes, and seconds. ![]() When used as a clock, the time can be shown in 12 or 24 hour formatting. Dual or quad output timer capability is done through the use of an option card. The panel meter features two inputs with 23 timing ranges. Dimensions: 1.95" x 3.8" x 4.2" Red Lion PAXCK010 Real Time Clock/Timer Panel Meterīesides the real time clock feature, it is also able to show the date and Altitude: Up to 2000 meters Construction: NEMA 4X/IP65 outdoor use, IP20 Touch Safe, Installation Category II, Pollution Degree 2, One piece bezel/case flame resistant Synthetic rubber keypad panel gasket & mounting clip Connection: High Compression Cage-Clamp Terminal Block Wire Strip Length: 0.3" (7.5 mm) Wire Gage: 30-14 AWG copper wire Torque: 4.5 inch-lbs (0.51 N-m) max. Shock to IEC 68-2-27: Operational 25 g (10 g relay). relative humidity (non-condensing) Vibration to IEC 68-2-6: Operational 5 to 150 Hz, 2 g. If enabled, filter results in 50 msec start/stop response time for successive pulses on the same input terminal Standards Compliance CE Approved EN 61326-1 Immunity to Industrial Locations Emission CISPR 11 Class A EN 61010-1: General Requirements EN 60: Particular Requirements for Testing and Measuring Circuits RoHS Compliant UL Recognized Component: File #E179259 UL Listed: File #E137808 Type 4X Enclosure rating (Face only) IP65 Enclosure rating (Face only) IP20 Enclosure rating (Rear of unit) Physical Operating Temperature: 0 C to 50 C (32 F to 122 F) Storage Temperature: -40 C to 60 C (-40 F to 140 F) Humidity: 85% max. Filter enabled or disabled through programming. Filter: Software filtering provided for switch contact debounce. Timer Start/Stop Response Time: 1 msec max. Current Sourcing (active high): VIH = 3.6 V min., 22 KOhm pull-down, Max. Current Sinking (active low): VIL = 0.9 V max., 22 KOhm pull-up to +12 VDC. with or without AM/PM indication) Date Display: 7 display formats Month/Day or Day/Month (numeric or 3-letter Month format) Month/ Day/Year or Day/Month/Year (all numeric) Day of Week/Day (3-letter Day of Week format) Cycle Counter Display Counter Range: 0 to 999999 Digit Resolution: 1 cycle Maximum Count Rate: 50 Hz Timer Inputs A & B Logic inputs configurable as Current Sinking (active low) or Current Sourcing (active high) via a single plug jumper. Maximum Display: 999999 Real Time Display 5 display formats Hr/Min/Sec (12 or 24 Hr. Maximum Least Significant Digit Resolution: 1 Hr. Isolation To Timer Input Common: Not isolated Response Time: 10 msec Timer Display Timer Range: 23 Selectable Ranges Timing Accuracy: +/- 0.01% Minimum Digit Resolution: 0.001 Sec. Short circuit protected Memory Nonvolatile E2PROM retains programmable parameters & display values User Inputs Three programmable user inputs Logic inputs configurable as Current Sinking (active low) or Current Sourcing (active high) through a single plug jumper. to all inputs and outputs Sensor Power 12 VDC, +/-10%, 100 mA max. ![]() Specifications Display 6 digit, 0.56" (14.2 mm) red sunlight readable LED Annunciators: TMR- Timer, CNT- Cycle Counter, DAT- Real time clock date or time SP1 - setpoint 1 output state, SP2 - setpoint 2 output state, SP3 - setpoint 3 output state, SP4 - setpoint 4 output state Power Requirements DC Power: 11 to 36 VDC, 14 W (Derate operating temperature to 40 C if operating <15 VDC and three Option cards are installed)ĪC Power: 24 VAC, +/- 10%, 50/60 Hz, 15 VA After setup parameters can be partially or completely locked to avoid tampering.Communication & Bus Capability (w/Option card).4 Setpoint Alarm Outputs (w/Option card).4 Displays- Timer, Clock, Date, Counter.Four setpoint outputs are possible through the use of an optional digital output card. There are 5 function keys on the front, with 3 being programmable to meet the requirements of the application. Inputs sources include switch contacts or CMOS & TTL circuit outputs. It can also provide communication and bus capability through option cards, such as RS232, RS485, Modbus, DeviceNet, and Profibus-DP. It features a 6 digit, red LED display in a 1/8 DIN housing. The Red Lion PAXCK010 PAX series panel meter is a timer with real-time clock capability. ![]()
0 Comments
Leave a Reply. |